Jeep CHEROKEE User Manual page 16

In this situation, a back up method can be
used to operate the ignition switch. Put the
nose side (side opposite of the emergency
key) of the key fob against the START/STOP
ignition button and push to operate the igni-
tion switch.
NOTE:
Improper disposal of key fob batteries may
be harmful to the environment. Please see an
authorized dealer for proper battery disposal.
To Unlock The Doors And Liftgate
Push and release the unlock button on the
key fob once to unlock the driver's door or
twice within five seconds to unlock all doors
and the liftgate.
All doors can be programmed to unlock on
the first push of the unlock button. Refer to
"Uconnect Settings" in "Multimedia" in the
Owner's Manual for further information.
NOTE:
If the vehicle is unlocked using the interior
door panel, and no door is opened within 60
seconds, the vehicle will re-lock and if
equipped, the security alarm will arm. To
change the current setting, refer to "Ucon-
nect Settings" in "Multimedia" in the Owner's
Manual for further information.
14
This feature lets you program the system to
unlock either the driver's door or all doors on
the first push of the unlock button on the key
fob. To change the current setting, refer to
"Uconnect Settings" in "Multimedia" in the
Owner's Manual for further information.
NOTE:
If the vehicle is equipped with Passive Entry,
refer to "Keyless Enter-N-Go — Passive
Entry" located in "Doors" in this chapter for
further information.
To Lock The Doors And Liftgate
Push and release the lock button on the key
fob to lock all doors and liftgate.
The turn signal lights will flash and the horn
will chirp to acknowledge the signal. Refer to
"Uconnect Settings" located in "Multi-
media" in the Owner's Manual for further
programmable information.
If the vehicle is equipped with Passive Entry,
refer to "Keyless Enter-N-Go — Passive
Entry" located in "Doors" in this chapter for
further information.
Vehicles Equipped With Keyless Enter-N-Go —
Passive Entry
If one or more doors are open, or the liftgate
is open, the doors will lock. The doors will
unlock again automatically if the key fob is
left inside the passenger compartment,
otherwise the doors will stay locked.
Request For Additional Key Fobs
NOTE:
Only key fobs that are programmed to the
vehicle electronics can be used to start and
operate the vehicle. Once a key fob is
programmed to a vehicle, it cannot be
programmed to any other vehicle.
WARNING!
Always remove the key fobs from the

vehicle and lock all doors when leaving
the vehicle unattended.
For vehicles equipped

Enter-N-Go — Ignition, always remember to
place the ignition in the OFF mode.
with Keyless