Daily Use - Washing & Drying - Zanussi ZWD76NB4PW User Manual

more or less than the default size, the appliance
adjusts automatically the time value during the
cycle.
2. Press to start the programme.
The display shows the door locked indicator
The drying indicator
You cannot set all dryness levels for
any type of laundry.
TIMED DRYING
The laundry can also be dried with a manual timed
drying:
1. Press again and again to set the time value
(see the «Programmes for timed drying» table).
• The display shows 10 minutes. Each time
you press this touchpad the time value
increases by 5 minutes.
• The display shows the set time value: for
example –
• After some seconds the display shows a
new time value:
calculates also the duration of the anti-
crease and the cooling phases.
2. Press to start the programme.
• The display shows regularly a new time
value.
• The drying indicator
DAILY USE - WASHING & DRYING
WARNING! Refer to Safety chapters.
This appliance is an automatic washer
dryer.
NON-STOP PROGRAMME
1. Turn the programme knob to the desired
programme to activate the appliance.
2. Load the laundry one item at a time.
To have a good drying performance do
not exceed the maximum drying loads
recommended in the user manual. Do
not set a spin speed lower than the
automatic speed of the set
programme.
3. Put the detergent and the additives in the
appropriate compartment.
22
starts to flash.
.
. The appliance
starts to flash.
• The display shows the door locked indicator
.
If you set only 10 minutes of drying,
the appliance performs only a cooling
.
phase.
If the laundry is not sufficient dry, set
again a short drying time.
END OF THE DRYING PROGRAMME
The appliance stops automatically.
• The acoustic signals operate (if they are active).
• In the display
• The indicator
• The last minutes of the drying cycle the
appliance performs a cooling and anti-crease
phase. The door is still locked.
When the door locked
you can open the door.
1. Turn the programme knob to
the appliance.
After some minutes from the end of the programme,
the energy saving function automatically
deactivates the appliance.
2. Remove the laundry from the appliance.
Make sure that the drum is empty.
3. Keep the door ajar, to prevent mildew and
odours.
4. Close the water tap.
4. Turn the programme dial to the washing
programme.
The display shows the indicators of the different
washing phases.
5. Set the available options.
WASHING & AUTOMATIC DRYING
1. Press again and again until the display
shows one of the dryness level indicator:
• : IRON DRY level indicator for cotton
items
• : CUPBOARD DRY level indicator for
cotton and synthetic items
• : EXTRA DRY level indicator for cotton
items
The display shows the indicator
on the display is the duration of the washing +
drying cycles, calculated on a default load size.
comes on.
goes off.
goes off in the display,
to deactivate
. The time value