Zanussi ZWD76NB4PW User Manual page 31

Hide thumbs Also See for ZWD76NB4PW:
Table of Contents

Advertisement

Problem
The programme does
not start.
The appliance fills with
water and drains imme-
diately.
The spin phase does
not operate or the
washing cycle lasts lon-
ger than usual.
There is water on the
floor.
You cannot open the
appliance door.
The appliance makes an
unusual noise and vi-
brates.
The programme dura-
tion increases or de-
creases during pro-
gramme execution.
The washing results are
not satisfactory.
Too much foam in the
drum during the wash-
ing cycle.
Make sure that the mains plug is connected to the mains socket.
Make sure that the appliance door is closed.
Make sure that there is no damaged fuse in the fuse box.
Make sure that the Start/Pause
If the delay start is set, cancel the setting or wait for the end of count-
down.
Deactivate the Child Lock function if it is on.
Check the position of the knob on the selected programme.
Make sure that the drain hose is in the correct position. The hose may
be positioned too low. Refer to "Installation instruction".
Make sure that the drain filter is not clogged. Clean the filter, if neces-
sary. Refer to "Care and cleaning".
Adjust manually the items in the tub and start the spin phase again.
This problem may be caused by balance problems.
Make sure that the couplings of the water hoses are tight and there is
not water leakages.
Make sure that the water inlet hose and the drain hose have no dam-
ages.
Make sure you use the correct detergent and the correct quantity of it.
Make sure that a washing programme that ends with water in tub, has
not been selected.
Make sure that the washing programme is finished.
Make sure that the appliance receives electrical power.
This problem may be caused by a failure of the appliance. Contact the
Authorised Service Centre.
If you need to open the door, please read carefully "Emergency door
opening".
Make sure the levelling of the appliance is correct. Refer to "Installa-
tion instruction".
Make sure that the packaging and/or the transit bolts are removed.
Refer to "Installation instruction".
Add more laundry in the drum. The load may be too small.
The TimeCare System is able to adjust the programme duration ac-
cording to the type and the laundry load size. Refer to "The TimeCare
System load detection" in "Daily Use" chapter.
Increase the detergent quantity or use a different detergent.
Use special products to remove the stubborn stains before you wash
the laundry.
Make sure that you set the correct temperature.
Decrease the laundry load.
Reduce the quantity of detergent.
Possible solution
has been touched.
31

Advertisement

Table of Contents
loading

Table of Contents