Advertisement
Application
In order to raise the boom extension, close release valve of the hydraulic cylinder. Then attach
•
the lever to the hydraulic cylinder and utilise it by pumping until the boom extension has
reached the desired height.
The boom length can be extended by removing the bolt and the nut placed in the same, be-
•
fore pulling the boom extension out until the pre-drilled holes overlap. Now reinsert the bolt
and secure it with the appropriate nut.
WARNING! The maximum lifting capacity of the crane must not be exceeded. Infringement
•
can lead to severe damage and injuries. Please be aware that the maximum lifting capacity
decreases with an increasing boom length.
Position the crane in a way that the object to be lifted is placed directly beneath the hook.
•
By slightly opening the release valve the hook can be lowered, before the item you want to lift
•
can then be attached to the hook. Once the item has been attached to the hook, make sure
that the safety latch of the hook is completely closed. The close the release valve and utilise
the lever to raise the boom.
Exercise extreme caution when lifting loads, ensure that they have been secured appropriately
•
and make sure that they do not swing. Inappropriately secured or swinging loads carry an in-
creased risk of falling off the hook.
Once the item has been lifted out of its mount, lower the boom in order to be able to slowly
•
and carefully transport the item.
Maintenance
Always make sure to check the entire device before each use in order to ensure that the crane
•
is in pristine condition.
Make sure that the hook and chain are clean and thereby free from grease, dirt and debris.
•
In case the hydraulic system of the crane does not operate correctly, air might have entered
•
the same. Please abide to the following steps in order to remove the air from the system:
First make sure that the boom is in its home position (the boom is completely lowered).
◦
Remove the oil fill plug and pour some additional hydraulic oil into the tank.
◦
Now begin to pump until the boom has reached its maximum height.
◦
Open the release valve and press the boom down until the cylinder has been completely
◦
retracted.
Add some more hydraulic oil and reinsert the oil fill plug.
◦
Repeat these steps if necessary.
◦
We advise the use of a wet towel in combination and a mild detergent for cleaning purposes.
•
In case of a decrease of lifting capacity, please check the device's oil level and replenish it if
•
necessary.
Important notice:
The reprint or reproduction, even of excerpts, and any commercial use, even in part of this instructions
manual require the written permission of WilTec Wildanger Technik GmbH.
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Item 61031
Page 6
11 2020-1
Advertisement
