Advertisement
Operation Manual
Steam Wallpaper Stripper
62283
Illustration similar, may vary depending on model
Read and follow the operating instructions and safety information before using for the first time.
Technical changes reserved!
Due to further developments, illustrations, functioning steps and technical data can differ insignific -
antly.
Updating the documentation
If you have suggestions for improvement or have found any irregularities, please contact us.
Advertisement
Table of Contents
Related Manuals for WilTec 62283
Summary of Contents for WilTec 62283
- Page 1 Operation Manual Steam Wallpaper Stripper 62283 Illustration similar, may vary depending on model Read and follow the operating instructions and safety information before using for the first time. Technical changes reserved! Due to further developments, illustrations, functioning steps and technical data can differ insignific - antly.
- Page 2 All rights reserved. The WilTec Wildanger Technik GmbH cannot be held accountable for any possible mistakes in this operating manual, nor in the diagrams and figures shown.
- Page 3 Do not disassemble the device; only have repairs carried out by trained personnel. © by WilTec Wildanger Technik GmbH Item 62283 Page 3 http://www.WilTec.de http://www.aoyue.eu...
- Page 4 3 Length (m) of cable Running time (min) approx. 70 main device 30×26×21 Size (cm) steam panel 28×20 Weight (kg) approx. 2,4 Protection type IPX4 © by WilTec Wildanger Technik GmbH Item 62283 Page 4 http://www.WilTec.de http://www.aoyue.eu 2021-1 http://www.teichtip.de...
- Page 5 5. Now wait for the water to be heated before you start working. We advise to place the applic- ator inside a bucket until it is ready. It approximately takes 15 min for the device to reach its service temperature. © by WilTec Wildanger Technik GmbH Item 62283 Page 5 http://www.WilTec.de...
- Page 6 Do not submerge the device in water or other liquids and do not use chemical cleaning agents or oils. Attention: Maintenance of the electric parts of the wallpaper stripper should only be performed by specifically trained personnel. © by WilTec Wildanger Technik GmbH Item 62283 Page 6 http://www.WilTec.de http://www.aoyue.eu 2021-1 http://www.teichtip.de...
- Page 7 All WilTec electric devices that fall under the WEEE regulations are labelled with the crossed-out wheeled waste bin logo. This logo indicates that this electric equipment must not be disposed with the domestic waste.
Need help?
Do you have a question about the 62283 and is the answer not in the manual?
Questions and answers