WilTec 62058 Operation Manual

Three-roll bending machine

Three-roll Bending Machine

62058

Illustration similar, may vary depending on model

Please read and follow the operating instructions and safety information prior to initial operation.

Technical changes reserved!

Illustrations, functional steps and technical data may deviate insignificantly due to continuous further

developments.

Table of Contents

Need help?

Do you have a question about the 62058 and is the answer not in the manual?

Page 1 Operation Manual Three-roll Bending Machine 62058 Illustration similar, may vary depending on model Please read and follow the operating instructions and safety information prior to initial operation. Technical changes reserved! Illustrations, functional steps and technical data may deviate insignificantly due to continuous further...
Page 2 The information contained in this document may alter at any time without prior notice. No part of this document may be copied or otherwise duplicated without prior written consent. All rights reserved. WilTec Wildanger Technik GmbH cannot be held liable for any possible mistakes in this operating manual, nor in the diagrams and illustrations shown.
Page 3 • Store the device in a safe place when not using it for a long time. • Keep it in a dry, well-ventilated place and out of children’s reach. © by WilTec Wildanger Technik GmbH Item 62058 Page 3 http://www.WilTec.de http://www.aoyue.eu...
Page 4 • After bending, loosen all fixing elements (fixing screws, adjustment screws, etc.). Remove roll 1 (10) to be able to remove the piece on the right side of the machine. © by WilTec Wildanger Technik GmbH Item 62058 Page 4 http://www.WilTec.de...
Page 5 Gear wheel Roll 1 Screw Important Note: Reproduction and any commercial use (of parts) of this operating manual, requires a written permission of WilTec Wildanger Technik GmbH. © by WilTec Wildanger Technik GmbH Item 62058 Page 5 http://www.WilTec.de http://www.aoyue.eu 11 2021-1...