Table of Contents
Advertisement
1.3
POWER CARD
The power card is housed in the top-left slot of the panel and has four indicator lights.
The indicators and adjustments are listed below, some of which are not applicable to
cotton gins. Also included is information on power supply fusing.
• AC Power Indicator (AC Power) on panel door (28 volt bulb): Normally "ON" unless
AC power fails or the bulb fails.
• LED-1 green DC Power Indicator (PWR): Normally "ON" unless fuse F-1 blows (as
long as the battery is connected to the system and fuse F-2 is in the circuit)
LED-2 green Battery Charged Indicator (CHGD):
•
LED-3 amber Battery Discharging Indicator (DISCH):
•
uses.
LED-4 amber Battery Charging Indicator (CHNG):
•
P-2 Voltage Regulator
•
across detector output terminals pins 1 & 3) with maximum load on system.
applicable to cotton gin uses.
P-1 Battery Charging Voltage Regulator (Potentiometer):
•
uses.
• SH1 Battery "YES/NO" Indicator: Jumper should be placed on pins towards desired
side.
NOTE: For cotton gin applications, make sure the black jumper is placed on the
pins on the NO side.
Argus Installation and Resource Guide
(Potentiometer): Adjust for 24 volts DC +/- 0.1 volts (measure
Figure: Power Card
COMPONENTS
Not applicable to cotton gin uses.
Not applicable to cotton gin
Not applicable to cotton gin uses.
Not applicable to cotton gin
Not
4
Advertisement
Table of Contents
