Table of Contents
Advertisement
4. With the number of detectors and appropriated placement determined, take the metal
template mark the location of each of the three holes per detector on your pipe.
Note: The template holes should be lined up along the length of the pipe, not around the
pipe. Incorrect installation will result in detector failure.
5. With the holes marked take the ¼" drill bit from the installation kit and using a drill, cut
out the marked holes. Ream out the outside holes a small amount for easier bolt
installation.
Argus Installation and Resource Guide
Figure 1: Mark the holes using the template
Figure 2: Drill each marked hole using the ¼" bit
SUPPLEMENTAL
30
Advertisement
Table of Contents
