ORiNOCO AP-9000R Hardware Installation Manual page 15

.
Step 12: Power ON the Device
After connecting the PoE Injector and the device using straight-through CAT5e cable plug the power cord into a power
outlet. There is no ON/OFF switch on the device. To power down the unit, unplug the RJ45 connector from the OUT / POE
port on the PoE injector.
Step 13: Port LED Indicators
When the device is powered on, it performs startup diagnostics. When startup is complete, the LEDs show the device's
operational state. The LEDs are located on the Ethernet port inside the device enclosure.
: The LEDs will not be visible when the weather-sealing cap is installed.
The LEDs can be seen at the bottom of the Ethernet port. The following table describes the status of LEDs:
LED State
Status LED Ethernet link is down
Gigabit LED Ethernet link is established at
100 Mbps
®
ORiNOCO AP-9200R - Hardware Installation Guide
Figure 4-6 Ground the Device
Figure 4-7 Port LED Indicators
Off
Ethernet link is active
Ethernet link is established at 1 Gbps
Device Installation
On
15