ORiNOCO AP-9000R Hardware Installation Manual page 12

Step 6: Assemble Mounting Hardware
1. Place the L-Shaped Mounting Bracket onto the bottom of the device and align with the four mounting holes.
2. Insert the screws and washers into the four mounting holes as shown in Figure 4-2 view (B).
3. Tighten the screws to the required torque. The last image in Figure 4-2 view (C) shows the fully assembled mounting
hardware attached to the device.
Step 7: Mount the Device
1. To pole-mount the device to a 1.5 to 3.25 inch diameter pole, place the fully assembled mounting hardware along
with the device against the pole and insert the U-bolt through the holes provided on full axis plate on the Mounting
Bracket.
2. Insert the Toothed Washer, Spring Washer, Flat Washer and Nut on both ends of the U-bolt as shown in Figure 4.
3. Tighten the nut slightly so that the U-bolt is adjustable for pole mounting. After adjusting the angle of the device, fully
tighten the nut.
Step 8: Plug in the Cables
®
ORiNOCO AP-9200R - Hardware Installation Guide
Figure 4-2 Assemble the Mounting Hardware
Figure 4-3 Pole Mounting
Device Installation
12