Canon imageFORMULA DR-6030C User Manual page 51

Replacing the Pickup Roller
When cleaning or replacing the pickup roller, feed rollers or retard
roller, use the appropriate procedure to remove and replace the
rollers.
CAUTION
• Turn ON the power to the scanner to remove or attach the pickup
roller. Be careful when working on the scanner when the power is
ON.
• Do not use excessive force when removing or attaching the rollers.
Doing so may damage them.
Removing the Pickup Roller
1
Turn ON the power.
Hint
Because the pickup roller locks when the power is OFF, it will not fall
forward when the upper unit is opened.
When the power is OFF
2
Open the upper unit smoothly.
When the power is ON
(See p. 50)
3
Push up on the pickup roller to open the hook, and then
remove the pickup roller.
4
Install the new Pickup Roller. Hold the new pickup roller
(or the one you removed) by both sides of its shaft, and
place it on the hooks.
IMPORTANT
Take note of the orientation of the pickup roller. Putting it in
backward and forcing it may damage the scanner.
51