Microlife PF100 Instruction Manual page 16

8. It is recommended to perform three
or more measurements sequentially.
9. After each measurement, the actual
reading is shown followed by the
highest reading of your current
measurement session.
10.Press the ON/OFF button again to
switch the monitor off. Before the
monitor switches off, the highest
value of the current measurement
session and its related memory
position MR XX is displayed.
11.Clean the tube and mouthpiece
after use (see section 8).
Please note:
• The monitor only saves the highest reading from a
measurement session (--measurements taken in one
on/off cycle).
• The date and time must be set for the unit to take a
measurement.
• The device stores up to 240 measured values with date and
time. When the memory is full, the oldest values are
automatically erased. Make sure you visit your doctor
in time to analyze your data.
• Please confirm that date and time settings are always actual.
• The performance of the monitor can be affected by
extremes of temperature and humidity. See technical
specifications section for details.
15