Seat Clamping - Precede:on; Gear System Enviolo Automatiq - Canyon Pedelec Manual

24 SEAT CLAMPING – PRECEDE:ON
SEAT CLAMPING –
PRECEDE:ON
To adjust the height of the seat post and thus
the seat height for the rider on the PRECEDE:ON,
proceed as follows.
First push up the rubber cover.
Undo the Allen bolt on the clamping mechanism
(at the back of the seat tube), which clamps the
seat post tight in the seat tube, anticlockwise by
one turn. Do not undo the screw fully as it is an
essential part of the clamping system.
The clamping mechanism consists of
two parts which are held in place by a
small screw at the back of the clamping
mechanism. This screw cannot be seen from
the outside, i.e. when installed. The screw was
adjusted at the factory and may neither be
(partially or fully) removed nor modified.
You can now adjust the height of the seat post.
If the seat post does not move, undo the screw
a bit further. In some cases it may be necessary
to cautiously tap the saddle toward the front or
back along the longitudinal axis to help the seat
post and the clamping mechanism come loose.
Take care to observe the minimum and maximum
markings printed onto the post.
For more information read the chapter "Adjusting
the saddle to the correct height" in your com-
prehensive world-specific Canyon bicycle manual.
Once you have adjusted the saddle to the cor-
rect height, tighten the Allen bolt on the clamping
mechanism to 7 to 8 Nm torque. Use a torque
wrench. Finally, push the rubber cover back over
the clamping mechanism until the clamping
mechanism is fully covered.
Tighten carefully by approaching the
prescribed maximum torque value in
small steps (0.5 Nm increments) while check-
ing the proper seat of the component in be-
tween. Never exceed the maximum torque
value indicated by Canyon!
GEAR SYSTEM
ENVIOLO AUTOMATiQ
The enviolo AUTOMATiQ gear system is an auto-
matic continuously variable gear system without
discrete gear steps.
In Automatic mode, a software automatically ad-
justs the gear ratio to the rider's desired pedalling
cadence. This means you are no longer required
to change gears but can simply set your ideal ca-
dence.
The gear system automatically adapts the gear
ratio in such a way that the defined cadence is
maintained, no matter the topography, traffic situ-
ation, weight of the luggage, etc.
For instance, the gear system will recognize re-
ductions in speed or pedalling cadence when
approaching a red light and adapt the gear ratio
accordingly. This means you are able to start up
again in a suitably smaller gear.
The cadence should be above 60 crank
revolutions per minute; riders of road
bikes typically even reach 100 revolutions or
more.

GEAR SYSTEM ENVIOLO AUTOMATiQ

The cadence is set directly at the Bosch display.
At the KIOX display by Bosch, keep the
Info button pressed to directly access
the menu for setting the pedal cadence.
The enviolo AUTOMATiQ system can be
configured and diagnosed with the
enviolo AUTOMATiQ app. You find more infor-
mation in the operating instructions of the
gear manufacturer. Alternatively, use our ser-
vice hotline or the contact form on our web-
site, www.canyon.com
Remove the rechargeable battery or the
display before doing any work on your
Canyon pedelec (e.g. servicing, repairs, assem-
bly, maintenance, work on your drive etc.). Acti-
vating the drive system unintentionally bears
the risk of injury!
25