Table of Contents
Advertisement
6. Controller Connector
Connect the stack cables to the lead wires of the T-sensor/
blower/purging valve/input valve on the controller.
7. Controller
Controls the stack temperature, blowers, hydrogen input,
purging and short circuiting of the stack.
8. H2 out & H2 In: connect tube in 10 below
H2 OUT: connect tube shown in 10 below.
H2 IN: connect tube shown in 10 below.
9. Fuel Cell +/- Load Connectors
FC+ is connected to the fuel cell positive pole.
FC- is connected to the fuel cell negative pole.
10 . Tube for H2 Input & Output
The tube with 6mm outer diameter and 3mm inner
diameter is connected to the H2 Inlet and outlet as in
9 above and to the input valve and output valve of the
hydrogen source.
11 . Fittings
For connecting the load.
H-1000 Fuel Cell Stack User Manual V4.4
11
Advertisement
Table of Contents
