modway EEI-2155 Quick Start Manual

Office chair

Table of Contents

Download this manual

EEI –2155

OFFICE CHAIR

Thank you for purchasing the MODWAY OFFICE CHAIR！！！！

Before you start, here is some helpful advice:

1.We suggest you spend a short time reading through this leaflet and then follow the simple step by step

instructions.

2.Owing to the size and weight of the office chair, we recommend that it is assembled by two adults, on a carpeted

or padded area, in the room that it is intended for. Approximate assembly time: 15 minutes.

3.Please do not use any tools other than those provided or recommended in these instructions.

4.Please do not throw away any of the packaging or instructions until you have checked all the components and

hardware and the furniture is fully assembled.

5.Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten the

components from time to time, so please save the tools that have been provided.

6.Please keep all pieces out of reach of small children.

Chair Back with Arm

Cylinder Column

Customer Service 908-368-1025︱︱︱︱ www.modwayfurniture.com

Chair Seat

Chair Base

Bolt M6x18mm

Allen Wrench

Plastic Cover

Control Mechanism

Castor

Page 1 of 4

Table of Contents

Need help?

Do you have a question about the EEI-2155 and is the answer not in the manual?

Page 1 EEI –2155 OFFICE CHAIR Thank you for purchasing the MODWAY OFFICE CHAIR！！！！ Before you start, here is some helpful advice: 1.We suggest you spend a short time reading through this leaflet and then follow the simple step by step instructions.
Page 2 EEI –2155 OFFICE CHAIR STEP 1: Please put the Chair Base (E) upside down on a carpeted or padded surface. Insert 1pc of Castor (F) into the Chair Base (E) as shown by hand. Repeat the same steps for the other 4pcs of Castor (F). STEP 2: Place a sealed carton on the floor with a carpeted or padded surface on the top side of carton.
Page 3 EEI –2155 OFFICE CHAIR STEP 3: Attach the Control Mechanism (C) into the bottom of Chair Seat (B) by using 4 piece of Bolts (1) as shown. Use Allen Wrench (2) to tighten the Bolts (1) clockwise until secure. 1x4pcs 2x1pc Hardware &...
Page 4 EEI –2155 OFFICE CHAIR STEP 5: Insert the assembled Chair Base (E) into the Cylinder Column (D) as shown. STEP 6: Carefully turn over the office chair. Place the armrests to the correct position for using. Customer Service 908-368-1025︱︱︱︱ www.modwayfurniture.com Page 4 of 4...