Advertisement
Quick Links
COB LED MOTION SENSOR LIGHT
Please read these instructions carefully before use and retain for future reference.
IMPORTANT SAFETY INFORMATION
•
Avoid locations of high temperature or humidity.
•
If the light output becomes less bright or flashes, replace the batteries.
•
Always remove the batteries if the light is not to be used for long periods.
•
Never mix new and old batteries or mix different battery types.
INSTALLATION
•
Separate the head from the mounting by gently pulling them apart then turn the rear
half on the head anticlockwise and remove it.
•
Remove the battery cover and insert the batteries noting the correct polarity then
replace the cover and slide the switch to either on or auto position.
•
Replace the rear half of the head unit then refit the head unit into the mounting.
PELL0010
Switch
Advertisement
Related Manuals for Pro-Elec PELL0010
Summary of Contents for Pro-Elec PELL0010
- Page 1 COB LED MOTION SENSOR LIGHT PELL0010 Please read these instructions carefully before use and retain for future reference. IMPORTANT SAFETY INFORMATION • Avoid locations of high temperature or humidity. • If the light output becomes less bright or flashes, replace the batteries.
- Page 2 • Drill the wall or ceiling in the required location with regard to any concealed wiring or pipework, use a wall plug if required and screw in a dome head screw leaving the head 4mm proud of the surface. • Locate the keyhole slot in the base of the light unit over the screw head and ensure the light is securely fixed.