Advertisement
Please read these instructions carefully before use and retain for future reference.
IMPORTANT SAFETY INFORMATION
•
Avoid locations of high temperature or humidity.
•
For indoor use only.
•
If the light output becomes less bright or flashes, replace the batteries.
•
Always remove the batteries if the light is not to be used for long periods.
•
Never mix new and old batteries or mix different battery types.
INSTALLATION
•
Remove the rear cover by prising off using a flat blade in the slot at the bottom edge.
•
Insert the batteries noting the correct polarity and replace the cover.
•
Drill the wall in the required location with regard to any concealed wiring or pipework,
use a wall plug if required and screw in a dome head screw leaving the head 4mm
proud of the surface.
•
Locate the keyhole slot in
the rear of the light unit over
the screw head and ensure
the light is securely fixed.
Keyhole slot
3 LED MOTION SENSOR LIGHT
PELL0009
Batteries
Advertisement
Table of Contents
Related Manuals for Pro-Elec PELL0009
Summary of Contents for Pro-Elec PELL0009
- Page 1 3 LED MOTION SENSOR LIGHT PELL0009 Please read these instructions carefully before use and retain for future reference. IMPORTANT SAFETY INFORMATION • Avoid locations of high temperature or humidity. • For indoor use only. • If the light output becomes less bright or flashes, replace the batteries.
- Page 2 • Alternatively use the double sided adhesive pads to mount the light unit if the surface is unsuitable for screw mounting. OPERATION • The motion sensor will turn on the light when movement is detected in low light environments. • After all motion ceases to be detected, the light will extinguish after 25 seconds.
Need help?
Do you have a question about the PELL0009 and is the answer not in the manual?
Questions and answers