Advertisement
Please read these instructions carefully before use and retain for future reference.
IMPORTANT SAFETY INFORMATION
•
Avoid locations of high temperature or humidity.
•
For indoor use only.
•
If the light output becomes less bright or flashes, replace the batteries.
•
Always remove the batteries if the light is not to be used for long periods.
•
Never mix new and old batteries or mix different battery types.
INSTALLATION
•
Remove the rear cover and insert the batteries noting the correct polarity.
•
Replace the cover and slide the switch to either on or auto position.
•
Drill a hole in the wall where required with regard to any concealed wiring or pipework.
Fit a wall plug if required and screw in a
dome head screw leaving the head 4mm
proud of the surface.
•
Locate the keyhole slot in the rear of the
light unit over the screw
head and ensure the light
is securely fixed.
4 LED MOTION SENSOR LIGHT
PELL0008
Switch
Batteries
Keyhole slot
Advertisement
Table of Contents
Related Manuals for Pro-Elec PELL0008
Summary of Contents for Pro-Elec PELL0008
- Page 1 4 LED MOTION SENSOR LIGHT PELL0008 Please read these instructions carefully before use and retain for future reference. IMPORTANT SAFETY INFORMATION • Avoid locations of high temperature or humidity. • For indoor use only. • If the light output becomes less bright or flashes, replace the batteries.
- Page 2 OPERATION • In AUTO mode the motion sensor will turn on the light when movement is detected only in low light environments. • After motion ceases to be detected, the light will extinguish after 25 seconds. • When in the ON mode the light will remain permanently lit.
Need help?
Do you have a question about the PELL0008 and is the answer not in the manual?
Questions and answers