Minelab MF5 Operation Manual page 19

Tone
Mode Change
Interrogation Mode:
Ferrous Target
Interrogation Mode:
Carbon Rod / Fine Wire
Interrogation Mode: Non-
Ferrous Target
Pinpoint Mode
Ground Balance IED
Operations
Ground Balance
Conventional Operations
Default Sensitivity
Selected
Sensitivity Not Default
Changing Sensitivity
Volume Default
Event
Entering or exiting Interrogation
or Pinpoint Mode.
Indicates target likely to be ferrous.
Indicates target likely to be carbon
rod or fine wire.
Indicates target likely to be
non-ferrous.
Indicates proximity of target to
centre of coil via a static response
such that the target feedback will
be heard even if the detector coil is
stationary with respect to
the target.
Indicates that Sensitivity knob has
been changed into IED Operations
from Conventional Operations.
Indicates that Sensitivity knob has
been changed into Conventional
Operations from IED Operations.
Confirms to Operator that
Sensitivity knob is at Position IED
3 (Default) when the detector is
switched on or Position IED 3 is
selected whilst the detector is
in use.
Indicates that the default sensitivity
is not selected when detector is
switched on.
Increasing or reducing sensitivity.
Indicate that the volume setting is
set to the default value.
Description
When entering Interrogation Mode
a single mid pitched beep. When
exiting Interrogation Mode a double
mid pitched beep.
Single beep with very
low-pitched tone.
Single beep with very
high-pitched tone.
Medium to high-pitched tone
proportional to the target
conductivity.
Increasing to the maximum
pitch when the detector coil is
immediately adjacent to the
target centre.
One higher pitched beep followed by
one lower pitched beep.
One lower pitched beep followed by
one higher pitched beep.
Double mid-pitched beep.
Single low-pitched beep if sensitivity
lower than default (IED 3) and single
high-pitched beep is sensitivity
higher than default.
When increasing sensitivity a single
high-pitched beep, except when
increased to default value. When
decreasing sensitivity a single
low-pitched beep, except when
decreased to default value.
Double beep at volume 6.
Functional Description | 19