Minelab MF5 Operation Manual page 12

Metal and conductive detector
Hide thumbs Also See for MF5:
Table of Contents

Advertisement

MF5 Preparation (continued)
5� Extend for operation
Extend the Lower and Middle Shafts
to suit standing, kneeling or prone
operating positions.
NOTE: The MF5 requires four C cell batteries for operation. Use only high quality NiMH
rechargeable or Alkaline batteries. Minelab recommends that only rechargeable batteries with
capacity of 4000 mAh or greater to be used with the MF5.
Rechargeable batteries have specific charge / discharge maintenance requirements which
should be strictly followed to ensure maximum battery life
• Do not mix old and new batteries.
• Do not mix different battery brands.
NOTE: Electronics within the MF5 ensure that its performance remains consistent as the
charge state of the batteries begins to reduce. A Battery Low Alarm will occur when there is
approximately 30 minutes of battery life remaining.
Important Safety Warnings and Advice: When the Critically Low Battery Alarm occurs
the Operator must immediately STOP operations. The MF5 should be switched off and
new or recharged batteries inserted.
CAUTION — Risk of explosion if battery is replaced by an incorrect type.
12 | Getting Started

Advertisement

Table of Contents
loading

This manual is also suitable for:

4901-0373-1

Table of Contents