Ocean Rodeo Go Joe Manual page 5

Step Three
Pump up until firm.
Recommend inflation
pressure is 3 PSI.
Over inflation may
rupture the bladder
our cause seam
failure.
Don't store your Go Joe inflated in a hot vehicle. When
inflated on the beach, store out of direct sunlight.
HOW TO REPAIR YOUR GO JOE
Go Joe's are tough, but they occasionally need a little
TLC. Your Go Joe comes complete with a patch kit to
handle small bladder holes. If your bladder has a major
tear, you can order a new bladder via a link on Go Joe
product page at www.oceanrodeo.com
To find and fix a leak, first you must remove the bladder.
To do this detach the valve cap and push the valve inside
the Dacron tube. [1] [2]
Next step remove the nylon tube slip covers from the
molded plastic base plate. It's OK to aggressively bend
1
the base plate as it's made
with rugged / flexible
plastic. [3]
Next, open the side access
zippers (there are two
access zips) and remove
the bladder. You will notice
a small Velcro tab on one
end of the bladder; this is
used to hold the bladder
in place, and should be re
attached when re installing
the bladder.
If the leak is not visible,
inflate the bladder and
apply soapy water to the tube. Bubbles will show the
leak. Circle the hole with pen. [4]
2
3
4