Ocean Rodeo Go Joe Manual page 4

CONGRATULATIONS ON YOUR GO
JOE PURCHASE.
We hope you enjoy the fast board recovery and excellent
visibility provided by the Go Joe. The extra floatation is
also very helpful while executing a self-rescue.
Please take a few minutes and read over the install/
maintenance information to ensure you have the
ultimate Go Joe experience.
The Go Joe takes just a few minutes to install.
Tools Required:
Pump (the same pump you use for your kite), screw
driver, grab handle with screws (we've included slightly
longer than standard screws M6
Metric) to accommodate the extra
thickness of the Go Joe base plate.
Step One:
Insert the end of the grab
handle into the webbing
loop/base plate assembly.
Pass the screw through
hole in grab handle and
holes in both the base
plate and webbing loop.
Step Two:
Position Go Joe so screws line up with the grab handle
inserts on your board. Adjust the angle of the Go Joe
base plate so it does not extend past the edge of the
board. Position the Go Joe at a slight angle so it fits
comfortably along your leg while riding.