Nap203 - ZyXEL Communications NAP Series User Manual

Table 4 NAP303 LEDs (continued)
LED
Management
WLAN
WLAN
UPLINK
LAN
Locator

1.6.2 NAP203

The LEDs will stay ON when the NAP203 is ready. You can change this setting with LED suppression.
Chapter 1 Introduction
COLOR STATUS
Green On
Slow Blinking (On for 1s,
Off for 1s)
Amber Slowly blinks amber for
one second and green
Green
for one second
alternatively.
Amber Blinks amber and green
alternatively 3 times
Green
and then turns solid
green for 3 seconds.
Green On
Off
Green On
Off
Amber/ On
Green
Blinking
Off
Amber/ On
Green
Blinking
Off
White Blinking
Off
NAP Series User's Guide
DESCRIPTION
The NAP is managed by the NCC.
The NAP is connected to the NCC, but not registered.
The NAP is searching for (discovering) the NCC.
The NCC is connecting to the registered NAP.
The 2.4 GHz WLAN is active.
The 2.4 GHz WLAN is not active.
The 5 GHz WLAN is active.
The 5 GHz WLAN is not active.
Amber - The port is operating as a 100-Mbps connection.
Green - The port is operating as a Gigabit connection
(1000 Mbps).
The NAP is sending/receiving data through the port.
The port is not connected.
Amber - The port is operating as a 100-Mbps connection.
Green - The port is operating as a Gigabit connection
(1000 Mbps).
The LAN port is sending/receiving data through the port.
The LAN port is not connected.
The Locator is activated and will blink to show the actual
location of the NAP between several devices in the
network.
The Locator function is off.
16