Advertisement
Quick Links
PlateMate Installation
FIRST TIME INSTALLATION
•
Please read instructions carefully before installation.
•
Check the contents of kit. Contact your YAKIMA
dealer if any parts appear missing or damaged.
•
Place these instructions in the vehicle's glove box
after installation is complete.
KIT CONTENTS
1
ITEM
COMPONENT
1.
Back Plate
2.
Knurled Nuts
3.
Screws
4.
Velcro Straps x3
1
INSERT VELCRO STRAPS
Take x2 Velcro Straps and thread through
the front of PlateMate as shown.
Pull Velcro Straps completely
through as shown.
6100003124-Rev1
®
3
2
QTY
4
x1
x2
x2
NOTE:
Strap confi guration
shown is for Yakima
HoldUp.
PlateMate can
also be attached
to other carriers
using the other slot
combinations.
2
POSITION NUMBER PLATE
Position your number plate onto the
PlateMate. Using the x2 Screws,
line up the Screws through slots
in your number plate with the
appropriate holes in PlateMate.
3
SECURE NUMBER PLATE
Turn PlateMate over carefully ensuring
that the screws don't fall out. Spin
the Knurled Nuts onto screw threads.
Finger tighten nuts until number
plate is secure on PlateMate.
6100003124-Rev1
Advertisement
Related Manuals for Yakima PlateMate
Summary of Contents for Yakima PlateMate
- Page 1 • Please read instructions carefully before installation. appropriate holes in PlateMate. • Check the contents of kit. Contact your YAKIMA dealer if any parts appear missing or damaged. • Place these instructions in the vehicle’s glove box after installation is complete.
- Page 2 2x Velcro Straps as shown below. The remaining Velcro Strap can be threaded through one of the lower slots in PlateMate to prevent swinging if you opt to attach PlateMate to the rearmost bicycle on the carrier.
Need help?
Do you have a question about the PlateMate and is the answer not in the manual?
Questions and answers