Table of Contents
Advertisement
Troubleshooting
5
Troubleshooting
5.1
General troubleshooting procedure
1. Try to solve the problem with the information in this manual.
See § 5.3.
2. If it is not possible to solve the problem with the information in
this manual, contact service. See § 5.2.
5.2
Contact service
1. Find the type plate on the rear of the machine. See § 3.1.5.
2. Take a note of the model number and the serial number of the
machine.
3. Contact your supplier or manufacturer.
See www.fast-fluid.com.
5.3
Error messages and other faults
Problem
The display shows 'E01'
The display shows 'E02'
The display shows 'E03'
The display shows 'E07'
The display shows 'E08'
All other codes
Note
See the column Possible solution to solve the
problem. When the problem persists, contact
service. See § 5.2.
Possible cause
No clamp current.
Pressure not reached.
The door is open.
No can detected during clamping.
Emergency stop switch is pressed.
-
SK300 CE
20
Possible solution
Contact service. See § 5.2.
Contact service. See § 5.2.
Close the door. See § 3.2.4.
Place the can. See § 3.2.4.
Release the emergency stop switch.
See § 3.2.8
Contact service. See § 5.2.
V. 1.0
Advertisement
Table of Contents
