Mefu MF1700-M1+ Manual
  1. Manuals
  2. Brands
  3. Mefu Manuals
  4. Laminator
  5. MF1700-M1+
  6. Manual

Mefu MF1700-M1+ Manual

Full-auto heat-assist cold laminator
Hide thumbs

Advertisement

Table of Contents

Laminate Your Value
Full-auto Heat-assist Cold laminator
1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the MF1700-M1+ and is the answer not in the manual?

Questions and answers

Related Manuals for Mefu MF1700-M1+

Summary of Contents for Mefu MF1700-M1+

  • Page 1 Laminate Your Value Full-auto Heat-assist Cold laminator...

  • Page 2: Table Of Contents

    Single-side Full-auto Heat-assist Cold laminator MF1700-M1+ represent the highest industrial product Warning Symbols by Mefu for high end market. It has been the most human and efficiency laminating machine ever. Safety With a laminating and mounting width up to 1620mm(64''), ensures most application possibilities.

  • Page 3: Summary

    Laminate Your Value Controller for lifting up Summary Warning Symbols and down the roller To know clearly about this manual for using safely with Roller Speed controller flatbed, you need to be familiar with the warning symbols in this manual. SET button emp/Set up emp/Set down...

  • Page 4: Safety

    Laminate Your Value Safety In order to make a full understanding of the machine, please read this Emergency situations manual carefully before operation. Take care when operating the In the event of an emergency, Press the emergency stop button to stop the machine, especially if more than one operator is using it.

  • Page 5: Installation And Notice

    Laminate Your Value Installation and Notice The MEFU Laminator should be assembled and used in a clean Before use room with a normal room temperature and normal humidity Check the chains and gears (at a regular time), clean and lubricate.

  • Page 6: Operation

    Laminate Your Value Operation 3. Connect this tube (from this machine) to the 1. Turn over the working table for laminating. 2. Install the oil-water separator air outlet of oil-water separator. 4. Connect the tube (from air compressor) 5. Install the pedal switch. 6.
  • Page 7 Laminate Your Value 7. Place the roll of cold film and paper tube to the upper rolls (film roll and release 8. Fix the mandrel liner roll), place the roll of graphic and paper tube to the the lower rolls (feeding roll and finish product roll), and measure them straightly with scale on the rolls.
  • Page 8 Laminate Your Value 13. Feed into the graphic. 11. Pass the film through the laminator. 12. Pull out the film and stick to the paper tube. 14. Put down the roll to keep the feeding graphic steady. 15. Using graphic beam, keep graphic 16.
  • Page 9 Laminate Your Value 18. Using Hot/Cold lamination switch, pre-heating for the upper 19. Press the “Continue” switch to 17. Lift down the roller. roller. Press SET button, heat the upper roller (with recommended temperature of 40-50 ℃ for heat-assist cold lamination or 90-100 ℃ laminate.

  • Page 10: Maintenance

    Laminate Your Value Troubleshooting Maintenance 1.Reset the emergency stop button. The roller won’t move Every day 2.Reset the controls · Make sure that the machine is not held any hard stuff and the roller is not up and down (If none of this helps, please contact a damaged.

  • Page 11: Repairs

    The equipment may only be used for its intended Model FMJ-1700-M1+ purposed as specified in this manual. For any other Max width 1630mm use may result in damage or injury, and is at the Speed Up to 6m/min user’s own risk. Laminating type Heat-assist Cold Heating method...

Table of Contents

Save PDF