Table of Contents
Advertisement
System settings
14.3 Activation of system settings in system mode
Normal
If HMWIN runtime is not running:
operation
Touch the "System Setting" button on the touch terminal to open the system set-
tings in user mode. Select "Restart" > "Config OS" to reboot in system mode.
If HMWIN runtime is running:
Touch and hold any unused area of the touchscreen for a few seconds to access
the context menu. The default holding time is 2 seconds. Select "System Setting"
from the context menu. Select "Restart" > "Config OS" to reboot in system mode.
Recovery
If the touch terminal is not responsive, tap on the surface of the touchscreen during
operation
the power-up phase. The tapping frequency must be high. Start tapping the touch-
screen as soon as power has been supplied to the product.
The message "TAP-TAP DETECTED" appears when the operating sequence has
been recognized. Release the touchscreen to boot in user mode without running
HMWIN runtime or touch and hold the touchscreen for a few seconds. Then select
"Restart" > "Config OS" to boot in system mode.
14.4 Options available in system settings
The following important basic setting options of the touch terminal are available:
Language
System
Logs
Date & Time
Network
Services
Management
Display
Restart
Authentication
NOTE
There are more options available in the system settings that are not described and not documented in
this manual. For details, refer to the HMWIN User Manual.
Configure the language used for the system setting menu only.
Shows information about platform, status and timers (e.g. system
on time, backlight on time).
Enable continuous log for BSP and allow to export it.
Change the date and time of the product, including time zone and
NTP server.
Configure the IP address of the Ethernet interface and the other
network settings, e.g. DNS, gateway, DHCP, hostname, routing
and bridging.
Enable/disable services, e.g. OpenSSH server, bridge, cloud
services, router, SNMP and logging.
Update BSP components (Main OS, Config OS, Boot loader,
XLoader), check partition consistency, update the splash screen,
show the usage and size of partitions.
The update of "Main OS" is only available in system mode. The
update of "Config OS" is only available in user mode.
Adjust the display brightness, configure automatic backlight turn-
off and select panel orientation (90°, 180°, 270° and 360°).
Restart the product.
Select "Main OS" to restart the product in user mode. Select
"Config OS" to restart the product in system mode and open the
system settings.
Configure the administrator ("admin") and standard user ("user")
password. An administrator has full access to the "System
Settings" (e.g. BSP updates and other system components). A
standard user has some limitations.
24
Advertisement
Table of Contents
