Vehicle Ignition Lock-Out; Troubleshooting; Disposal; Limited Warranty - Dometic POWER AWNING PRO Installation Manual

Wireless Receiver
Once programmed, the sensitivity can be adjusted at
any time without reprogramming. The sensitivity of the
wind sensor can be set from 1 (most sensitive) to 9 (least
sensitive). Settings 0 and 5 are for programming only
and are not active settings.
I For safety purposes, the wind sensor sends a
signal to the receiver every 60 minutes to confirm
functionality. If for any reason (removal, low battery,
etc.) the signal is not received after 60 minutes, the
awning will retract automatically.

8 Vehicle Ignition Lock-out

When the vehicle ignition is in the ACC, ON, or START
position, the receiver has the ability to retract/lock/cut
power to the awning.
When the vehicle ignition is in the OFF position, the
awning is unlocked and will operate normally.
q
ON
w
ON
4 Vehicle Ignition Lock-out
Ignition ON
q
EN
Ignition OFF
w

9 Troubleshooting

Problem Possible Cause
Unable to pair the The receiver
remote control or has reset before
wind sensor initiating the next
step in the pairing
Wind sensor The wind sensor
keeps beeping; battery may be
awning low. (The receiver
automatically will retract the
retracts every 30 awning every 30
minutes minutes to protect
the awning.)
Awning The wind sensor
automatically is out of place.
retracts every 60 (The receiver will
minutes retract the awning
every 60 minutes
to protect the

10 Disposal

Place the packaging material in the appropriate
M
recycling waste bins, whenever possible. Consult
a local recycling center or specialist dealer for
details about how to dispose of the product in
accordance with all applicable national and local
regulations.

11 LIMITED WARRANTY

LIMITED WARRANTY AVAILABLE AT
WWW.DOMETIC.COM/WARRANTY.
IF YOU HAVE QUESTIONS, OR TO OBTAIN A COPY
OF THE LIMITED WARRANTY FREE OF CHARGE,
CONTACT:
DOMETIC CORPORATION
CUSTOMER SUPPORT CENTER
5155 VERDANT DRIVE
ELKHART, INDIANA 46516
1-800-544-4881 OPT 1
Vehicle Ignition Lock-out
Recommended
Solution
Restart the pairing
process and
complete each
step within four
process. seconds of the
previous step.
Replace the wind
sensor battery.
Locate the wind
sensor and put it
back in place.
awning.)
7