Verifying The Remote Control; Pairing The Wind Sensor - Dometic POWER AWNING PRO Installation Manual

Pairing the Wind Sensor

Step Operation
7
Press Down button
one time
8
Press the Left P2
button one time
9 Proceed immediately to "Verifying the Remote
Control" on page 6.

6 .3 Verifying the Remote Control

After pairing the remote control and the receiver, verify
remote control functionality by doing the following:
1. Press the Down button. The awning should extend.
2. Press the Up button. The awning should retract.
– If either button does not perform as expected,
see "Pairing the Remote Control" on page 5
and restart the pairing process.
3. Upon successful verification, proceed to "Pairing the
Wind Sensor" on page 6 (if applicable).
7 Pairing the Wind Sensor
NOTICE: Do not rely on the wind sensor to prevent
damage to the awning. The awning should always be
closed when unattended or when strong rain, wind, etc.
is expected.
The wind sensor is a key component to protect your
awning from the wind. This section describes how to
pair the wind sensor to the receiver and program the
sensitivity level. The information below applies to all
compatible power awning pro models.
Complete each pairing step within four seconds
I
of the previous step to keep the receiver in pairing
mode. If the receiver resets, restart the pairing
process.
6
Audible Awning
Alert Movement
None None
Beep x1
Awning jogs
Step Operation
1
Remove the front
cover of the Wind
Sensor
2
Set Sensor Dial
to 0
3
Press Remote Left
P2 button one time
4
Press Remote Left
P2 button one time
5
Press Sensor
Programming
button one time
6
Set Sensor Dial
to 5
7
Press Sensor
Programming
button one time
8
Set Sensor Dial to
desired level
Wireless Receiver
Audible Awning
Alert Movement
None None
None None
Beep x1
Awning jogs
None None
Sensor
Beep x1
Awning jogs
Receiver
Beep x5
None None
Sensor Beep
x1
Awning
retracts
None None
EN