Wireless Receiver
6 Pairing the Remote Control
The power awning remote control must be paired with
the receiver to communicate. The pairing steps may vary
depending on the awning model. Follow the pairing
instructions for your awning model.
6 .1 Pairing the 9200 and 9500
Remote Control
Follow the steps below for the 9200 and 9500 awning
series only.
I
Complete each pairing step within four seconds
of the previous step to keep the receiver in pairing
mode. If the receiver resets, restart the pairing
process.
Step
Operation
1
Remove battery
cover from back of
remote
2
Turn the receiver
Power button ON
3
Press Left P2
button two times
4
Press Up
button
1
one time
5
Proceed immediately to "Verifying the Remote
Control" on page 6.
1
For the 9500 power awning, press the
instead of the
Up button.
EN
Audible
Awning
Alert
Movement
None
None
None
Beep x1
None
Beep x2
Beep x4
Awning jogs
Down button at step 4
6 .2 Pairing the 9100 Power Awning
Remote Control
Follow the steps below for the 9100 awning series only.
I
Complete each pairing step within four seconds
of the previous step to keep the receiver in pairing
mode. If the receiver resets, restart the pairing
process.
Step
Operation
1
Remove battery
cover from back of
remote
2
Turn the receiver
Power button ON
3
Press Left P2
button two times
4
Press Up button
one time
5
Press Left P2
button one time
6
Press Up button
one time
Pairing the Remote Control
Audible
Awning
Alert
Movement
None
None
None
Beep x1
None
Beep x2
Beep x4
Awning jogs
Beep x1
Awning jogs
None
Beep x1
5