Silvercrest SKMP 1300 D3 Operating Instructions Manual page 40

7. Place the mixing tool 20/21/22 onto
the axle 23 from below.
Ensure that the small metal pins on the
axle 23 slot into the recesses in the mix-
ing tool 20/21/22.
8. Figure A: press the mixing tool 20/
21/22 upwards slightly and rotate it
anticlockwise until it stops.
Adding ingredients
• You can add ingredients into the mixing
bowl 16 while the drive arm 19 is lift-
ed up.
• During mixing, you can add ingredients
through the filling opening 10 in the
splash guard 18:
- Reduce the speed to 1 - 2.
- Open the flap of the filling open-
ing 10.
- Add the ingredients.
- Close the flap of the filling open-
ing 10 again.
38 GB
Lowering the drive arm
DANGER of hand injuries by
crushing!
Never put your hands between the drive
arm and the housing. There is a risk of
injury from crushing when folding
down.
9. Press the unlock button 11 and move
the drive arm 19 all the way down. The
r b o
unlock button 11 pops out again.
T u
The device is now fully assembled. On work-
ing with the device: see "Basic operation"
on page 42.