Errors And Troubleshooting; Error Codes - U-Line MINI PAK'R H-1604 Manual

ERROR CODES

Consult the chart below if the Display shows an Error Code and the red LED flashes. Try the appropriate action for the
problem, then press the STOP/RESET Button to resume operation.
DISPLAY CODE ISSUE
E1 Cover open
E2 Jam/end of roll
E3 Temp. Too high
E4 Temp. Too low
E5 Temp. Not rising
E6 No roll detected
TROUBLESHOOTING
OPERATING ISSUE
No power to Mini Pak'r™
Machine
Film won't advance
Air Cushions do not hold air
Film jams frequently
Machine won't stop
automatically
π
CHICAGO • ATLANTA • DALLAS • LOS ANGELES • MINNEAPOLIS • NYC/PHILA • SEATTLE • MEXICO • CANADA
PAGE 7 OF 7

ERRORS AND TROUBLESHOOTING

ACTION
Make sure covers are closed
In case of jam, open belt cover and remove jammed film carefully.
Contact Uline for assistance. (800-295-5510)
Contact Uline for assistance. (800-295-5510)
Contact Uline for assistance. (800-295-5510)
Press stop/reset. This may clear the error. If not, display will show "sty" (standby). Advance the
film slowly at the front of the machine so the film roll rotates. The display should show the seal
temperature and then "rdy" (ready). If the error can't be cleared, contact Uline for assistance.
(800-295-5510)
CAUSES
Power cord is unplugged
Circuit breaker OFF
Power Swtich OFF
Main fuse is blown
Belt cover(s) open
Film Roll installed backwards
Using incompatible film
Air Fill Tube not inside film
Air Pump not working
Seals leaking
Too much air fill
Blade is dull
Drive belts are worn
Length control set to continuous
1-800-295-5510
RECOMMENDATIONS
Plug power cord into Mini Pak'r™ Machine and outlet
Turn circuit breaker ON at Electrical Panel
Turn Power Switch ON
Replace Mains Fuse
Tighten Belt Cover Screw with Screwdriver
Turn film roll around (page 2)
Install compatible roll
Reload film onto Air Fill Tube (page 2)
Contact Uline for assistance
Adjust seal temperature (page 5)
Reduce air fill (page 5)
Replace Blade (page 6)
Replace both Drive Belts (page 6)
Press + or – Length Control Buttons to set desired length
of Air Cushion production (page 4)
uline.com
0715 IH-1604