Table of Contents
Advertisement
14
COLOR SYNC CONTROLLER MOUNTING KIT REPLACEMENT
RISK OF ELECTRICAL SHOCK OR ELECTROCUTION
TURN power OFF at circuit breaker - Always disconnect power to
the pool light at the circuit breaker before servicing the light. Failure
to do so could result in death or serious injury to installer, service
person, pool users, or others due to electrical shock.
MOUNTING KIT CONTENTS (P/N 602159Z):
Gasket, Screws (x2), Grease Packet
•
To remove and install a new gasket:
1.
Remove the two front screws from the front plate.
2.
Carefully remove the controller, face plate and gasket from the outlet
box.
3.
Using a small flat-blade screw drive, disconnect the three (3) power
wires by loosen the three (3) screws on the connector terminals located
on the lower rear side of the controller. See page 12 for wiring diagram.
4.
Separate the gasket from the face plate and discard the gasket.
Front screw (x2)
Color Sync Controller Installation Guide
3 wire connector
screw terminal
Controller and Gasket
Gasket
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the COLOR SYNC CONTROLLER and is the answer not in the manual?
Questions and answers