Regal Genteq Evergreen OM Installation Manual

Evergreen OM (460V)
®
Outdoor Fan Motor
Installation Guide
• Read and follow all instructions carefully.
• Disconnect and lock-out power before installation and maintenance.
Working on or near energized equipment can result in severe injury or
death.
• Do not operate equipment without guards in place. Exposed
equipment can result in severe injury or death.
High Voltage POWER Connections
Step 1: Connect the Black L1 to Line Voltage L1 on the "LINE" side of
the contactor.
Step 2: Connect the Red L2 to the Line Voltage L2 on the "LINE" side
of the contactor.
Note: These wires should be powered continuously when the
unit disconnect is closed.
Step 3: Connect the Green/Yellow stripe ground wire to system ground.
Orange (850 RPM)
Yellow (1100 RPM) 24vac/PWM
Blue (Common) 24vac/PWM
Changing Rotation
From the factory, the motor will be set up for CCW rotation as viewed
from lead end.
The Yellow wire connected thru the 2 pin connector to the Violet wire and
the Orange wire connected thru the 2 pin connector to the Brown wire.
Step 1: To change the rotation from CCW to CW:
Disconnect the 2 pin connector and rotate it 180° so the Yellow
wire is connected to the Brown wire thru the 2 pin connector and
the Orange wire is connected to the Violet wire thru the 2 pin
connector.
CAUTION: Secure all wires including the Rotation Connecton out of the
path of the fan blade before starting the motor!
1
Regal Beloit America, Inc.
Customer Service: 866 503 8566
• Periodic inspections should be performed. Failure to perform proper
maintenance can result in premature product failure and personal
injury.
Low Voltage SIGNAL Connections
Single Speed Connection
Step 1: Speed Connection
A) For 8 pole speed (850 RPM)
B) For 6 pole speed (1100 RPM)
Step 2: Connect Blue wire to 24vac Common
PWM Connection
Step 1: Connect Yellow wire to PWM source
Step 2: Connect Blue wire to PWM Common
EVERGREEN
OM
(460V)
Yellow
Orange
Yellow
Orange
Genteq
1325 Heil Quaker Blvd.
LaVergne, TN 37086
thedealertoolbox.com
connect the Orange wire to 24vac
connect the Yellow wire to 24vac
Note: 1. Motor on/off operating is dictated by these inputs
2. Cap off unused wire with wire nut or electrical tape
Black (L1)
460 VAC
Red (L2)
Green/Yellow Stripe
System Ground
CCW (Factory)
Violet
Brown
Rotation Connector
CW
Brown
Violet
F O R M
G1150E
Revised
Sept. 2016
Connect line voltage
wires t o
the LINE side of
the contator