Introduction - Fujitsu BS2000 SE Series Manual

1 Introduction

The FUJITSU Server BS2000 SE Series unites the existing server lines S servers and SQ
servers in the server line SE servers.
Depending on requirements, the SE server contains all the system components needed for
operation as an overall application:
– /390-based BS2000 Server Unit
– x86-based Server Units with BS2000, Linux or Windows guest systems
– x86-based Application Units for operation under Linux, Windows or VMware
– Shareable tape and disk periphery
– A high-speed, server-internal infrastructure to connect the components with each other
and with the customer LAN or SAN.
Information on using the Quick Guide
This Quick Guide is intended for people who operate an SE server and contains short
instructions for the most important scenarios when placing the SE server in service. The
following requirements should be met:
Customer Support provides the customer with the SE server.
●
The desired BS2000 operating mode is set on each Server Unit.
●
A BS2000 system is configured and fully operational.
●
All necessary BS2000 devices are configured.
●
i
U41857-J-Z125-2-76
Please note the following:
The base system of the MU (M2000) as well as the iRMC of the MU have a pre-
defined administrator account admin at the time the SE server is delivered. In both
cases an initial password is preset, which you can ask for at the service.
Change the password immediately after you have logged in for the first time.
You may also change the validity time and the other password attributes.
You can access the password management as follows:
in SE Manager: Authorizations → User → Password management
–
on the iRMC: User management → iRMC S4 users
–
5