Cateye VOLT 400 HL-EL461RC Manual

RECHARGEABLE HEADLIGHT
HL-EL461RC
Manual
Before using the light, please read this manual
and the included separate sheet "LITHIUM-ION /
LITHIUM-ION POLYMER BATTERIES" thoroughly, and
keep them for future reference.
Copyright© 2017 CATEYE Co., Ltd.
EL461RC-170203 2
Light unit
Cartridge battery
(BA-2.2)
USB cable
(MICRO USB)
FlexTight™ bracket
(H-34N)
2 HOW TO MOUNT
Dial
Bracket
Rubber pad
1
Strap
CAUTION!
ENG
• Before your trip, please make sure the light is fi rmly mounted
to the bracket, it lights up, and the light is not blocked by
baggage, etc.
• Do not place it within children's reach.
• Always attention to the remaining battery power by check-
ing the indicator periodically while using.
• In preparation for unexpected battery shutoff, we recom-
mend you carry a spare cartridge battery and light.
• Mounting the light unit too close to a wireless computer
may adversely affect the reading of the computer.
• This product is water-resistant under normal daily use and
can be used in the rain. However, do not intentionally sub-
merge it in water.
1 HOW TO CHARGE
6 h
Standard Approx.
charging time
(USB 2.0)
To PC or USB
battery charger
USB cable
2
1
Charge jack
cover
2
4
3
*1
Screw
1. Connect the light unit to your PC or
a commercial USB battery charger
Charging on the cradle
using the USB cable. (
The switch or the indicator on the
cradle lights up, and charging starts.
Cartridge
battery
Indicator light: On Charging
Indicator light: Off Charging is completed
Cradle
* When your PC is in sleep state, the
unit cannot be charged.
* We recommend using 500+mA
(USB2.0) USB battery charger.
2. After charging is completed, remove
the USB cable, and install the charge
Indicator
jack cover.
1. Mount the bracket to the handlebar.
(
1
4
2. Insert the light unit into the bracket
until it clicks, and adjust the beam
angle. (
3. To remove the light unit, pull out it
forward while pressing down on the
release button (
* To re-adjust the beam angle, loosen
the dial enough to move the bracket,
Release and fi rmly tighten it after adjustment.
button
* The light can be mounted under the
5
handlebar.
• If the light unit or parts become dirty with mud, etc., clean
with a soft cloth which is moistened with mild soap.
Never apply paint thinner, benzine or alcohol; damage will
result.
• Dispose of used cartridge batteries appropriately according
to local regulations.
Before Initial Use
This unit is shipped with a small charge to check the light.
Be sure to charge it before use, according to the instructions
"HOW TO CHARGE".
* Charging and lighting times are ap-
– )
1 2
* The cartridge battery can be fast-
CAUTION!:
– )
• Be sure to tighten the dial by hand.
3
)
4
• Check the dial and screw (*1) on the
).
5
• Round off the cut edge of the bracket
proximate values, and will vary by en-
vironmental and user conditions.
charged by using the optional charging
cradle (about 3 hours of charging time).
Use a 1A or higher USB charging
adapter when charging by the cradle.
When you tighten it too hard with
a tool, the screw thread may be
stripped.
bracket periodically, and use them
without any loosening.
strap to prevent injury.