Hints For Your Work With The Tool; Maintenance; Storage; Waste Disposal And Environmental Protection - PrimAster PMGBS 7220 Operating Instructions Manual

6
1
The position of the eccentric drive does not have to be
considered when changing the blades. When the device
is switched on, the gear eccentric unit automatically
engages into the appropriate relief in the shearing blade.
The device is now ready for operation.

Hints for your work with the tool

The shrub trimmer cuts ornamental shrubs and light
undergrowth or bushes. The device is also well-suited for
ornamental cuts as, for example, for the care of graves.
The grass shears allow for clean cuts of lawn edges or
hardly accessible lawn areas.
As the device is operated with one hand please
be careful not to move the other hand near the
running cutting tools.

Maintenance

7
Clean the blade from any crushed plants and dirt. The
blades should be detached at least once a season for
the removal of debris. Lubricate the C pinion and the
GB | Operating Instruction
D back of the blade with a light oil. Do not lubricate the
motor and other parts. Should the blade become dull
after a long period of use, a spare part can be ordered.
Warning! The leading edges of the blades must be oiled
to ensure proper lubrication. If the leading edges are not
oiled, blade durability may be adversely affected.
2 If the cutting tools have become dull after long use
please replace them with original spare parts.
Clean the device using only a brush or cloth. Do never
wash down the device with water and do never dip the
device into water.
Apply protective spray to the blades after each use.
Replace blunt blades.
Always put on the blade guard after use.
Examine the tool for obvious defects and have it repaired
in an authorised service shop if required.

Storage

Always store the tool in a dry, clean place outside the
reach of children. Make sure that the place of storage
is frost-free.

Waste disposal and environmental protection

Before removing the installed accumulator with printed
board from your appliance, actuate the ON/OFF switch
and wait until the accumulator has fully discharged.
Then use a screwdriver to undo all screws on the appli-
ance and open the casing.
D
Remove the printed board with lithium ion cell and dis-
connect the connections on the accumulator/printed
board.
C
In line with the European Electrical and Electronic Equip-
ment Directive, after removing the printed board with
accumulator, you must deliver the appliance for environ-
mentally friendly recycling.
Information concerning the disposal of materials and de-
vices are available from your local administration.
We would, however, also be happy to handle the proper
disposal of the appliance with accumulator on your be-
half. To take advantage of this offer, send the appliance
to the service address provided in the operating instruc-
tions.
10
Please note the following instructions regar-
ding disposal:
Worn out electrical appliances and batteries
do not belong with your household waste.
Electrical appliances must be collected, recycled or
disposed of in an environmentally friendly manner.
Defective or spent batteries must be recycled
properly in accordance with the latest regulations
concerning battery and accumulator disposal.
Then hand in the printed board with lithium ion
cell at an accumulator/battery recycling point for
proper disposal.