Table of Contents
Advertisement
Plugging In Your AVC-2310
To plug in your AVC-2310:
1 Connect the power adapter. (See the Figures on
need help locating the ports on your AVC-2310.)
Note: You can set your AVC-2310 in its stand, as shown, or
you can lay it flat on your desk. Built-in rubber pads help
keep the AVC-2310 in place when it's not in its stand.
2 Turn on your computer if you haven't already done so, then
connect the AVC-2310 to your computer using the provided
USB 2.0 cable.
3 Insert the VideOh! CD into your CD-ROM drive.
4 Turn on the AVC-2310 by pressing the Power button. The LED
on the front of the AVC-2310 lights up. (See
page 4
for more information.)
Note: If the VideOh! Software Installation screen appears,
exit this screen.
Now you are ready to install the device drivers.
Plugging In Your AVC-2310
page 4
if you
Power LED Status on
5
Advertisement
Table of Contents
