Advertisement
10
When the Setup program displays an updated list of
currently installed host adapter types, verify that
APA-1425/50/60 SCSI Host Adapter, for NT 3.51
appears on the list.
11
Click Close, and exit Setup; then restart your PC
when you are prompted to do so.
12
When Windows NT starts again, insert the Adaptec
EZ-SCSI diskette #1 in the floppy disk drive.
13
Select Run from Program Manager's File menu.
Note:
If you are using Windows NT 4.0, click the
Start button, and select Run.
14
Type a:\setup and click OK to install Adaptec
EZ-SCSI.
15
When Adaptec EZ-SCSI is installed, continue with
Using the SlimSCSI Adapter on page 7.
6
Completing the Installation in OS/2
Here is some important information about using the
SlimSCSI adapter in computers running under OS/2:
OS/2 must already be installed on the PC before you
begin these installation steps. OS/2 does not support
installation from a CD-ROM drive connected to a
PC Card such as the SlimSCSI adapter.
OS/2 does not support hot-plugging. This means that
the SlimSCSI adapter and the devices connected to it
must be plugged in and powered
OS/2 and that you cannot remove the adapter (or
other PC Cards) while OS/2 is running.
Follow these steps to complete installation of the
SlimSCSI adapter under OS/2 versions 2.x, 3.0, or
4.0 (Warp).
1
Be sure that the SlimSCSI adapter is inserted in a
PC Card slot and that the SCSI disk drive and/or
other SCSI devices are connected to it and are turned
.
ON
2
Start OS/2.
3
Open the OS/2 System icon, then open the System
Setup icon. Double-click the Selective Install icon.
4
Click PCMCIA Support, select the PCMCIA system
appropriate to your PC, and click OK.
5
Click Install and follow the instructions that appear
on the screen. (You will be instructed to insert a series
of OS/2 diskettes.)
6
When the installation procedure is completed, click
OK.
7
Insert the Windows NT/OS2/Windows 95 Driver
diskette in drive A.
8
Open the OS/2 System icon, and then open the Sys-
tem Setup folder. Double-click the Device Driver
Installation icon.
9
Click Change, double-click the OS2 directory, and
click Install. The aha152x.add file is now installed on
your PC, and the required changes are made to your
config.sys file.
before you start
ON
AAAA AAAA
AA AAAA
AAAA AAAA
AA AA
AA
AA AA
AA AA
AA
AA
AA AA
AA AA
AA
AA AA
AA AA
AA AA
AA AA
AA
AA AA
AA AA
AA AA
AA AA
AA
AA AA
AA AA
AA AA
AA AA
AA
AA AA
AA AA
AA AA
AA AA
AAAA AAAA
AA AA
AAAA AAAA
AAAA
AAAA AAAA
AAAA AAAA
AAAA AAA
AAA
A
A A
A
A A
A A
A
A
A A
A A
A
A A
A A
A A
A A
A
A A
A A
A A
A A
A
A A
A A
A A
A A
A
A A
A A
A A
A A
AAAA AAAA
AAAA AAAA
AAAA AAA
AAA
A A
Advertisement
