Furuno DS-8500 Installation Manual page 43

After tightening the inner sheath by the gland, wind a grounding wire on the armor as
shown below. Then connect the grounding wire to the wing nut on the front of the chas-
sis.
Armor (for cable with no outer sheath)
2.6.2 How to connect the cables
For the cable connection details, see the interconnection diagram at the back of this
manual. After cable connection, seal the gland with putty for watertightness as shown
below.
1 2 3
Outer shield
Transducer
cable
Outer sheath Outer sheath
Wind the copper line of the
grounding wire (local supply).
4 5 6 7 8 9 10 11
Copper
strap
Grounding
terminal
Distributor
cable
Gland
Gasket
Armor
Connect the crimp-on lug
to wing nut on the front
chassis.
12
After clamping cable, seal cable
gland with putty for watertightness.
Clamp vinyl
sheath by cable
gland.
After cable
Wind a copper
connection
line on the
armor
2. WIRING
Inside of the
junction box
Inner sheath Inner sheath
Vinyl tape
2-13