Adaptec RAID 2410SA Hardware Installation Manual page 6

2410SA Enclosure Kit HIG.fm Page 5 Thursday, October 23, 2003 1:20 PM
4 Install the drive chassis into the computer cabinet, using the
screws provided in the Adaptec 2410SA Enclosure kit. (Your
computer cabinet may not look exactly the same as the one
shown in the example below.)
5 Install the Adaptec Serial ATA RAID 2410SA controller, if you
haven't already. Refer to the printed Adaptec Serial ATA RAID
2410SA Quick Installation Guide, included in the kit, for detailed
instructions.
6 Connect the SATA cables to the controller, following the
instructions provided in the Adaptec Serial ATA RAID 2410SA
Quick Installation Guide.
7 Connect the LED cable to the LED cable connector on the
controller. The connector and cable are keyed to fit together one
way only, as shown:
8 Close the computer cabinet and reattach the power cord.
5