Reset; Power Failure (Only Mains Operation); Battery + Battery Replacement (Only Battery Operation) - DURAVIT DuraSystem WD6002 000 000 Operating Instructions Manual

6.5 Reset

You can reset all settings to the factory settings (see table 1: Hygiene flush) and restart
the software with the reset function.
> Press the F1 and F3 buttons simultaneously for 3 sec.
The status LED flashes 3 times on the membrane keypad. The status LED flashes again
3 times after approx. 6 sec. The settings are reset to the factory settings.

7. Power failure (only mains operation)

No automatic hygiene flush occurs in the event of a power failure. However, the
settings made remain unchanged for 65 days. If the power failure should last for
longer than 65 days, the settings must be configured again once the power supply is
restored.
8. Battery + battery replacement
(only battery operation)
In order to increase the service level of the battery, the battery version of the hygiene
flush has a standby mode to which the system switches 10 sec. after the membrane
keypad is last used. You can display the current battery level (see 6.1 Standby mode).
y
5
4
3
2
1
1 2 3 4 5 6 7 8 9 10
Diagram 1: Approximate battery life in years
x - Number of flushes per hygiene flush interval
y - Years
x
29