Table of Contents
Advertisement
20.4 Section Control Room
In the section Control Room the menu Assign is used to define the Main Out which is used for
listening in the studio. For this output the functions Dim, Recall, Mono, Talkback and External
Input are automatically applied.
Additionally the channel will be shifted from the Hardware Outputs into the Control Room sec-
tion, and renamed Main. The same happens when assigning Main Out B or the Phones. The
original name can be displayed by the function Names in the View Options - Show at any time.
Phones 1 to 4 will have Dim (set in Settings) and a special routing applied when Talkback is
activated. Also putting them beside the Main Out increases the overview within the output sec-
tion greatly.
Dim. The volume will be reduced by the amount set
in Settings (F3), tab Mixer.
Recall. Sets the gain value defined in Settings -
Mixer.
Speaker B. Switches audio from Main Out to Main
Out B. The faders of the channels Main and Speak-
er B can be ganged via Link. Via Options / Key
Commands switching to Speaker B can also be
controlled by the F-keys F4 to F8.
Mono. Mixes left and right channel. Useful to check
for mono compatibility and phase problems.
Talkback. A click on this button will dim all signals on the Phones outputs by an amount set up
in the dialog Settings - Mixer. At the same time the control room's microphone signal (source
defined in Settings - Mixer) is sent to the Phones. The microphone level is adjusted with the
channel's input fader.
External Input. Switches Main monitoring from the mix bus to the stereo input defined in Set-
tings (F3). The relative volume of the stereo signal is adjusted there as well.
Assign. Allows to define the Main Out, Main Out
B, and up to four Phones outs.
The output for the Cue signal, which is usually
Main, can also be set to one of four Phones
outputs. The setting Cue/PFL to also controls the
PFL monitoring.
User's Guide HDSPe MADI © RME
46
Advertisement
Table of Contents
