Totalmix Midi Remote Control; Overview; Mapping - RME Audio Hammerfall HDSPe AIO User Manual

27. TotalMix MIDI Remote Control

27.1 Overview

TotalMix can be remote controlled via MIDI. It is compatible to the widely spread Mackie Control
protocol, so TotalMix can be controlled with all hardware controllers supporting this standard.
Examples are the Mackie Control, Tascam US-2400 or Behringer BCF 2000.
Additionally, the stereo output faders (lowest row) which are set up as Monitor Main outputs in
the Monitor panel can also be controlled by the standard Control Change Volume via MIDI
channel 1. With this, the main volume of the HDSPe AIO is controllable from nearly any MIDI
equipped hardware device.

30.2 Mapping

TotalMix supports the following Mackie Control surface elements*:
Element:
Channel faders 1 – 8
Master fader
SEL(1-8) + DYNAMICS
V-Pots 1 – 8
pressing V-Pot knobs
CHANNEL LEFT or REWIND
CHANNEL RIGHT or FAST FORWARD
BANK LEFT or ARROW LEFT
BANK RIGHT or ARROW RIGHT
ARROW UP or Assignable1/PAGE+
ARROW DOWN or Assignable2/PAGE-
EQ
PLUGINS/INSERT
STOP
PLAY
PAN
MUTE Ch. 1 – 8
SOLO Ch. 1 – 8
SELECT Ch. 1 – 8
REC Ch. 1 – 8
F1 - F8
F9
F10 - F12
*Tested with Behringer BCF2000 Firmware v1.07 in Mackie Control emulation for Steinberg mode and with Mackie
Control under Mac OS X.
Meaning in TotalMix:
volume
Main Monitor channel's faders
reset fader to Unity Gain
pan
pan = center
move one channel left
move one channel right
move eight channels left
move eight channels right
move one row up
move one row down
Master Mute
Master Solo
Dim Main Monitor
Talkback
Mono Main Monitor
Mute
Solo
Select
in Submix mode only: select output bus
load preset 1 - 8
select Main Monitor
Monitor Phones 1 - 3
User's Guide HDSPe AIO © RME
65