– Normal use: The wall installation units Unohab are intended for external building wall installation. The air outlet is on the external side of the wall via a stainless steel panel. A lockable plastic panel serves this purpose on the internal side of the wall with an integrated non-woven air filter class Coarse and sound insulation.
Mode of operation Unohab is equipped with an EC axial fan, which runs in a cyclical reversing mode. Thus, the supply air modes, whereby the outside air flows into the building, continuously alternate with extract air modes, whereby the indoor air is extracted from the building.
General building regulation requirements IMPORTANT The ventilation units with heat recovery Unohab can only be installed and operated in rooms with other room air- dependent fireplaces if the exhaust duct is monitored by special safety devices, which switch off the ventilation unit when required.
Further accessories and suitable system components, such as switching power supplies, an expansion module and a casing for the surface mounting of the controller, are available to expand the Unohab system. Details can be found in the current Unohab brochure and on the website: www.airflow.com...
– Wall sleeve and external grille/outdoor panel Before installing the unit Unohab, the wall installation sleeve and the grille outer panel must be mounted (see fig.3) . Furthermore, the concealed cable routing and all building or renovation measures in the installation space must be completed.
The unit must be isolated from the mains power supply before any maintenance and installation work or before opening the terminal compartment! The Unohab heat accumulator consists of an easy-to-clean ceramic stone. The ceramic heat accumulator can be rinsed with water as part of the regular overall maintenance of the ventilation unit. Proceed as follows: 1.
Need help?
Do you have a question about the Unohab and is the answer not in the manual?
Questions and answers