Operating Problems - Adaptec AMM-1510M User Manual

AMM-1525M/1510M/525M User's Guide
Be sure that SCSI parity is consistently enabled or disabled on
all devices on the SCSI bus. See The aspi2dos.sys ASPI Manager
in your Adaptec EZ-SCSI User's Guide for information on setting
SCSI parity on the host adapter.
If your problem is still not resolved, continue with the next section.

Operating Problems

The system will not boot after initial installation of your host adapter.
If both SCSI and non-SCSI hard disk drives are installed, then
the non-SCSI drive is always the boot device. Since the
AMM-1525M/1510M does not support booting from a SCSI
drive, you must always have a bootable IDE drive or bootable
SCSI subsystem installed in your computer.
If both the host adapter and SCSI drive LED always remain on,
then pin-1 orientation of the SCSI cable is probably reversed
between the host adapter and the drive. Make sure that pin-1
orientation is maintained throughout the bus as explained in
Connecting Internal SCSI Devices on page 2-11.
If you see the message Host Adapter Not Found At Port 340h,
check the I/O port address jumper setting. See I/O Port Address
(AMM-1525M/1510M Only) on page 2-7.
The system is having difficulties using a SCSI drive as drive D and a
standard hard disk as drive C .
Make sure the SCSI drive (D) is set to Not Installed or No Drive
Installed with your CMOS setup program.
Make sure the SCSI drive used as drive D is set to SCSI ID 0.
Check your drive manual for information on setting the SCSI
ID for that device.
If your system is running under DOS, make sure the disk has
an active DOS partition.
I installed my host adapter at IRQ 12, and it does not work properly.
What is wrong?
Another device such as a mouse may be using IRQ 12. Change
adapter's IRQ to the default value (IRQ 11) or to another value that
is not being used by another board in the computer. See Interrupt
Channel (IRQ) (AMM-1525M/1510M Only) on page 2-6.
A-4
AAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAA A
A A
AMM-1525M/1510M/525M User's Guide
A
A A
Stock Number: 510660-00, Rev. A
A A
A A Print Spec Number: 492932-00
A A
Current Date: 9/20/94
A AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA
AAAA
ECN Date: 9/27/94
AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA
A
A A
A A
Page: A-4 A A
A
A A
A A
AAAA AAAA AAAA A A A A