Setting Jumpers; Installing And Removing Jumper Connectors; Interrupt Channel (Irq) (Amm-1525M/1510M Only) - Adaptec AMM-1510M User Manual

AMM-1525M/1510M/525M User's Guide

Setting Jumpers

In most cases, you do not need to change any of the default jumper
settings; however, if you need to change any of them, do it before
installing your host adapter.

Installing and Removing Jumper Connectors

Configuring a jumper setting on the AMM-1525M/1510M/525M
involves installing or removing a small plastic jumper connector on
the pins of the jumper blocks. Installing a jumper (On) means to
install a small plastic jumper connector so that it covers both pins of
the jumper pin pair. Removing the jumper connector or having it
cover only one pin is the same as having no jumper installed (Off).
On

Interrupt Channel (IRQ) (AMM-1525M/1510M Only)

Pin pairs I2, I1, I0, and I9 on jumper block J10 allow you to configure
the IRQ for the host adapter.
Each AMM-1525M/1510M and expansion board installed in your
computer must be assigned a unique IRQ. The available settings are
I2 I1 I0 I9
I2 I1 I0 I9
* = Default
Note:
IRQ 9 is not recommended with Windows 3.x.
2-6
A AAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAA
A A
AMM-1525M/1510M/525M User's Guide
A
A A
Stock Number: 510660-00, Rev. A
A A
A A Print Spec Number: 492932-00
A A
Current Date: 9/20/94
AAAA AAAA A AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA
AAAA
Off Off
= IRQ 12 = IRQ 11 *
I2 I1 I0 I9
= IRQ 10 = IRQ 9
I2 I1 I0 I9
ECN Date: 9/27/94
AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA
A
A A
A A
Page: 2-6 A A
A
A A
A A
AAAA AAAA AAAA AAAA AAAA A A A A