KE2 Local Area Overview, Installation, And Setup Instructions page 8

Q.5.42 June 2018
Page 8
KE2 Local AreaDashboard & Alarms
Overview, Installation, and Setup Instructions
Click on the ? in any of the set-
5
point areas to show the limits for
those setpoints.
For example Room Temperature.
Click within the grey area to
6
make changes to a setpoint.
Setting a setpoint outside of the
7
limits
will return a "Validation failed"
7a
message.
For any changes to ModBus set-
8
points or device_name changes
you will be prompted for the
ModBus Device Login.
Defaults are ke2admin & ke2ad-
min, unless they were changed
on the authentication screen.
NOTE: This is a one time login
for your active session. The first
setpoint that's changed prompts
you for the password. Additional
setpoint changes on that control-
ler, or other ModBus controller's,
will not prompt for the password.
For security purposes, Logout when finished
9
making all ModBus changes.
10 The Success image will display to verify that
you have successfully logged out.
© Copyright 2018 KE2 Therm Solutions, Inc., Washington, Missouri 63090
Advanced View
5
6
8
10
7a
7
9