Figure 3-6. Selecting Host Adapter Scsi Id - Adaptec AHA-2740 User Manual

Host Adapter SCSI ID
Select Host Adapter SCSI ID to configure the SCSI ID (0-7)
setting for the host adapter. Figure 3-6 displays your choices. The
default setting is 7.
Each installed SCSI device must have a unique SCSI ID. SCSI ID
7 is normally assigned to the host adapter; SCSI IDs 0 and 1
should be reserved for SCSI hard disk drives.
If two host adapters are installed, each would have its own SCSI
bus, thus each host adapter would still be set to SCSI ID 7. Refer
to Chapter 2, Getting Started for additional information on SCSI
ID.
Host Adapter SCSI ID
Done=F10 <Edit Resources=F6>

Figure 3-6. Selecting Host Adapter SCSI ID

Adaptec AHA-2740 Series User's Manual
Stock Number: 510381-00 / Rev. C
Print Spec Number: 491709-00 Rev C
Current Date: 9/1/93
Configuring the Host Adapter
SCSI Channel A Configuration
( ) 7
( ) 6
( ) 5
( ) 4
( ) 3
( ) 2
( ) 1
( ) 0
<Cancel=ESC>
(Page 3-9)
ECN Date: 9/14/93
3-9