Table of Contents
Advertisement
33.6-46.3 kg (74-102 lbs) 46.3-61.7 kg (102-136 lbs)
The weight of this part or unit is more than 55 kg (121.2 lb). It takes specially
trained persons, a lifting device, or both to safely lift this part or unit. (C011)
CAUTION:
To avoid personal injury, before lifting this unit, remove all appropriate
subassemblies per instructions to reduce the system weight. (C012)
CAUTION:
CAUTION regarding IBM provided VENDOR LIFT TOOL:
v Operation of LIFT TOOL by authorized personnel only
v LIFT TOOL intended for use to assist, lift, install, remove units (load) up into rack
elevations. It is not to be used loaded transporting over major ramps nor as a
replacement for such designated tools like pallet jacks, walkies, fork trucks and such
related relocation practices. When this is not practicable, specially trained persons or
services must be used (for instance, riggers or movers). Read and completely
understand the contents of LIFT TOOL operator's manual before using.
v Read and completely understand the contents of LIFT TOOL operator's manual before
using. Failure to read, understand, obey safety rules, and follow instructions may
result in property damage and/or personal injury. If there are questions, contact the
vendor's service and support. Local paper manual must remain with machine in
provided storage sleeve area. Latest revision manual available on vendor's website.
v Test verify stabilizer brake function before each use. Do not over-force moving or
rolling the LIFT TOOL with stabilizer brake engaged.
v Do not raise, lower or slide platform load shelf unless stabilizer (brake pedal jack) is
fully engaged. Keep stabilizer brake engaged when not in use or motion.
v Do not move LIFT TOOL while platform is raised, except for minor positioning.
v Do not exceed rated load capacity. See LOAD CAPACITY CHART regarding
maximum loads at center versus edge of extended platform.
v Only raise load if properly centered on platform. Do not place more than 200 lb (91
kg) on edge of sliding platform shelf also considering the load's center of
mass/gravity (CoG).
v Do not corner load the platform tilt riser accessory option. Secure platform riser tilt
option to main shelf in all four (4x) locations with provided hardware only, prior to
use. Load objects are designed to slide on/off smooth platforms without appreciable
force, so take care not to push or lean. Keep riser tilt option flat at all times except for
final minor adjustment when needed.
v Do not stand under overhanging load.
v Do not use on uneven surface, incline or decline (major ramps).
v Do not stack loads. (C048, part 1 of 2)
> _
61.7-100 kg (136-220 lbs)
Chapter 4. Installing an optional 5U SAS expansion enclosure
65
Advertisement
Table of Contents
